|
RX-USB Converter 6ch
for Asia & Oceania Area only |
JPY 9,800-
|
| RX-USB Converter is developed by Powers & Aqua System. Contact Powers for the detail of this product. |
| Play computer games with your own R/C Transmitter |
|
|
| "RX-USB Converter" converts the R/C servo signals from R/C receiver to USB signals. You can enjoy functions of your own transmitter (exponential, dual rate, ABS...) on computer games and simulators. Real R/C transmitter enables fine and accurate operation that was not possible with ordinal game controllers. You will enjoy difficult games with your own transmitter. |
| Specification | |
| Hardware Requirements | IBM Compatible PC with USB port |
| OS Requirement | Windows 98 (SE), ME, 2000 Professional, XP *Even if your computer satisfies these requirements, it is not guaranteed that the converter will function on it.*The converter will not work on Windows 95, NT4.0 |
| Operable Software | All Games and Simulators that work with common USB game controller on PC. |
| Interface | USB 1.1 |
| Device Driver | Not required (driver in OS is used) |
| Controller Type | 4-axis 4-button game controller |
| Power Source | Not required. The power to this unit and receiver is provided through the USB port |
| Size | 56 x 45 x 20mm (Case Size) |
| Operable Receiver | 27MHz to 75MHz AM, FM, PCM/PPM receiver with more than 2 Channels. (Excludes Futaba PCM receiver) |
| Note | * It is not guaranteed that the converter
will function on every receiver. The converter might become instable with
some receiver. * This converter does not work with Futaba PCM / HRS receiver. If you use a Futaba transmitter, change the transmitter mode to PPM and use a FM-PPM receiver. * This converter does not work with Futaba PCM receiver. If you use a Futaba transmitter, change the transmitter mode to PPM and use a FM Receiver. * It is not required to use a receiver from the same manufacturer as transmitters' because this converter is used with transmitter and receiver close to each other. Even ordinary receiver with relatively poor reception can be used. * This converter works with high speed response type transmitter/receiver other than Futaba. However, if using different manufacture's receiver as transmitter, it is recommended to switch signal mode to normal PPM. * If signal reception is poor, connecting transmitter and receiver with direct servo controller cable is recommended. |
| Connection |
 |
Connect the servo connector of the converter to your
own R/C receiver, and connect the USB connector of the converter to the
USB port of your computer. |
| * R/C receiver, R/C transmitter, computer and software are not included. | |